Installation of gas, If your cooker adjusted for natural gas, Connection of the gas hose to the oven – Beko D 6623 T User Manual
Page 22: Cdution! make the oven connection to
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Installation of gas
*Before your appliance is connected
to the gas supply, check the ensure
that the gas category and pressure
specifications shown in the data plate
corresponds with your gas supply. If
necessary call authorized service for
adjusting to gas category.
*This appliance shall be installed in
accordance with the regulations in
force and only used in a well ventilated
space. Read the instructions before
installing or using this appliances.
In the interest of safety this appliances
must be installed and/or serviced by a
competent person as stated in the gas
safety regulations current editions.
* Please refer to the data plate for
details about gas supply and pressures.
* The appliance must not be installed
in a room without a window or other
controllable opening. If is installed in
a room without a door which opens
directly to tohe outside, a permanent
opening is required.
The air circulation should be 2 m3/h
per kW of burners.
If your cooker adjusted for
natural gas;
Natural gas valve must be easy
reachable position.
Connection of the gas hose to the oven
Convenient position is selected by interchanging the hose nozzle and
plug according to the location of the main gas inlet valve. If you make
a connection with a flexible metal hose , locate a seal between the
main gas pipe. The inner diameter of the flexible hose, which the
butane hose nozzle is connected, should be 6mm for the house-type
gas tubes.
The inner diameter of the flexible hose, which the natural hose nozzle
is connected, should be 15mm. The hose should tightly be fitted to
the hose nozzle by squeezing with a clamp.The plastic hose end is
soaked in hot water for one minute to soften and inserted fully into
the hose nozzle. The clamp is fastened securely by a screw driver. The
other end of the hose is connected to the gas valve with the same
operation.
The hose should be replaced before its last expiry date.
pl
^9
Hose nozzle
CdUtion!
Make the oven connection to
S
— the gas inlet valve, the hose
length must be short and be
^sure that there is no leakage.
______ The hose used should not be
longer than 125 cm for safety.
Gas leakage control
During control, be sure that the control knobs are closed and the
gas inlet valve is open. Apply soap bubbles to the connections for
leakage control. In case leakage exists, buble will appear. In such
case, check the gas connection immediately. Do not control gas
leaks by using fire.
Caution!
Never use lighter or match flame, for controlling the
gas leakage.
19
I