beautypg.com

Rear panel connections, Disc input, Note – Arcam Delta 60 User Manual

Page 4: Compact disc input, 1 o o o

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Delta 60 integrated amplifier handbook

Rear panel connections

Remove screws to release lid

Earth

terminal

® LOUDSPEAKER OUTPUTS (4-16n)

TAPE 2 TAPE1 TUNER CD ®

DISC

PO\A^R INLET

1 O o

o

L

o o o o o o

OUT

IN

OUT

IN

o

SWITCHEC

o

(SP2)

o

R

o o o o o o

SELECTOR

/

O

O

-MC-

-MM

Figure 1

All audio inputs and tape outputs are via RCA phono

connectors. All the phono sockets on the Delta 60 are marked 'L' for left
and 'R' foT right channels, with the left channels nearer the top of the
cabinet. Your connection leads will be marked 'L' and 'R' or will have a
white or biack plug for left and a red plug for right.

Disc input
For the purposes of playing records the Delta 60 can accept

both moving magnet and moving coil cartridges. For either type of
cartridge the plugs on your turntable lead should be connected to the disc
input sockets on the rear panel of the unit. A switch Just to the side of these

sockets allows the selection of either MM or MC input. The switch should
be left out for use with moving magnet or high output moving
coil cartridges and depressed for use with normal (low output) moving coil
cartridges.

If your turntable has a separate earth lead then this should be

attached firmly to the earth terminal on the rear of the amplifier.

MC/MM

cartridge

selector switch

Note

N

ever

operate

the

mm

/

mc

switch

on

the

rear

of

the

amplifier

with

THE VOLUME CONTROL TURNED UP AS THE RESULTANT ELECTRICAL SURGE MAY DAMAGE

YOUR LOUDSPEAKERS.

Compact Disc input
This input is suitable for use with any compact disc player (and

with our own Delta Black Box D/A converter coupled with a CD Player).

Connect your CD player to the amplifier using the phono sockets
marked CD.

Note

Although, like the tuner and tape inputs, the CD has a 'flat'

frequency response, its sensitivity is lower, to take account of the high
output signals generated by CD players. It is possible to use either a tuner
or another line source in the CD input but the amplifier's volume control

will have to be turned up to obtain a volume similar to that found when
using other inputs.