Avanti ELITE DG200W - Manual (Page 9)

HOW TO USE THE TOP BURNERS
GAS BURNERS
Gas flow to the burners is adjusted by turning the knobs which control the valves.
Turning the knob so that the indicator line points to the symbols printed on the panel
achieves the following functions:
Off
= Closed valve
= maximum rate
LO = minimum rate
The maximum aperture position permits rapid boiling of liquids, whereas the minimum
aperture position allows simmer warming of food or maintaining boiling conditions of
liquids.
To reduce the gas flow to minimum, rotate the knob further anti-clockwise to point the
indicator towards the [Q position.
Other intermediate operating adjustments can be achieved by positioning the
indicator between the maximum and minimum aperture positions, and never between
the maximum aperture and
Off
positions.
Figure 4
oo
•o
Off
=V;;i:W;BiWheh^thq:rariige;is;npibeihg!d^bdpetthe;:gasikn^
; ;and also olpse the ga^ ‘sh ut-bif-yaiydi placed: ph!theimain; gas aupiplyr line/i’
LIGHTING GAS BURNERS
In order to light the burner, you must:
1 - Turn the knob in an anti-clockwise direction up to the ¿
rate), push in and hold the knob until the flame has been lit.
The sparks produced by the lighter situated inside the relative burner will light the
flame.
In the event that the local gas supply conditions makes it difficult to light the burn­
er in ixflj position, try again with the knob in [Q position.
If there is no mains electrical supply, bring a lighted match close to the burner.
2 - Adjust the gas valve to the desired position.
To re-light the burner, return the knob to the
Off
position and repeat the operations for
lighting.
Figure 5
OFf
TherangP bebomes vep/
; Keep children weli bjirt of