Bolens 191-658 User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY INSTRUCTIONS
1. Open snow thrower carton.
2. A) Remove clutch rod
B) Remove cardboard insert 1, 2, & 3.
C) Remove bag of parts which is packed inside of insert #3.
D) Remove elbow & elbow insert.
E) Remove snow thrower.
1) Remove insert from underneath jackshaft pulley.
2) Remove last insert.
F)
Open small carton.
1) Remove push rod, stack control and lift spring.
3. Remove belt guard from tractor.
4. Remove hex bolt and sleeve holding the front of the belt guard to the engine. Do not remove the
belt
trapout.
Remove
bolt
and
rubber
washers
holding
the
rear
of
the
belt
guard
to
the
frame.
Depress
the
Clutch-Brake
Pedal
and
lock
in
the
brake
position
(fully
depressed
pedal)
with
the
parking brake.
If your tractor was manufactured after 1968 eliminate step No. 5.
5.
Loosen
the
bolt
holding
the
spring
tension
idler
and
belt
clip.
Mark
position
of
belt
clip.
Roll
belt off pulley TOWARDS the engine. Remove set screws (2) and pull off engine pulley. Refer to
Fig. 1. Replace bolt and two rubber washers in the frame.
BELT CLIP