Bolens 191-658 - Manual (Page 10)

STORAGE
1. Drive the tractor as close to the storage area as possible.
2. Disconnect the elbow crank and the clutch control rod.
3. Disconnect the adapter on the lift lever.
4. Remove special engine sheave and replace with original sheave;
5. Remove spring on left adapter plate.
6. Remove the right and left adapter plates. (It is not necessary to remove the guide arms from the
adapter plates.)
7. Wash off any dirt or salt on the snow thrower.
8. Paint or grease any bare metal.
9. Grease and lubricate the snow thrower as explained in the Lubrication section of this manual.
For one year from date of purchase, MTD Products Inc , will replace for the original purchaser, free
of charge, F.O.B. factory or authorized service firm, any part or parts found to be defective in material
or workmanship. All transportation charges on parts submitted for replacement under this warranty must
be paid by the purchaser. This warranty does not include replacement of parts which become inoperative
through misuse, excessive use, accident, neglect, improper maintenance or alterations by unauthorized
persons. This warranty does not include the engine, motor, battery, battery charger or any component
parts thereof. For service on these units refer to the applicable manufacturer’s warranty.
The above warranty will apply only to the original owner and will be effective only if the warranty
card has been properly processed. It will not apply where the unit has been used commercially.
Warranty service is available through your local authorized service dealer or distributor. UNDER NO
CIRCUMSTANCES WILL THE RETURN OF A COMPLETE UNIT BE ACCEPTED BY THE FAC­
TORY UNLESS PRIOR WRITTEN PERMISSION HAS BEEN EXTENDED.
When ordering replacement parts, please order from:
Haban Manufacturing Company
Mound and Marquette Street
Racine, Wisconsin 53404
10