Alvin Table Drawer Designmaster User Manual
Designmaster table drawer assembly
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
DESIGNMASTER TABLE
DRAWER ASSEMBLY
1. Attach large draw face to drawer using two 1” black screws. When attached
correctly, bottom of drawer face should be aligned with bottom of drawer
2. Using eight remaining 3/4” screws, attach drawers to pre-drilled holes in underside of
51 1/4” tubes located under dust cover. Put screw through center hole in drawer
mounting bracket and screw into pre-drilled hole in tube.
PLEASE NOTE: When properly installed, larger shallow drawer will be on left and
deeper tool drawer (with lock) will be on right.