Attaching the snow blade to the tractor – Bolens 198-954A User Manual

Page 4

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

8. Assemble the lift brackets to the push bar

assembly. See figure 5..
A. Place cotter pins (15) in cross bar and bend

ends over.

B. Place lift bracket (23) on cross bar.

NOTE

Lift brackets must face forward as

shown in figure 6.

C. Next place spacer (31), another lift bracket

(23) Flat washer (30), lockwasher (29) and
secure with hex screw (28). See figure*6.

FLAT
WASHER

(30)

LOCKWASHER

(29)

HEX SCREW

(28)

FIGURE 5

FIGURE 6

Attaching the Snow

Blade to the Tractor

(SEE FIGURE 9)

1. Roll the tractor over the completely assembled

blade.

NOTE

The push bar assembly may rub on
the bottom of the transaxle.

2. Raise the rear of push bar assembly up and secure

to rear of tractor with hex bolt, flatwasher and

hex lock nut. See figure 7.

D. Assemble lift brackets on other side in same

order.

FIGURE 7