Defrosting your appliance, Using your ice cube trays, Evaporator drip tray – Avanti 31YWT User Manual
Page 11: Before using your appliance, Using your ice cube tray
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Defrosting Your Appliance
• When? For the most efficient operation and minimum energy consumption, defrost the appliance
compartment when the frost on the appliance walls is excessive or inch thick.
• How?
CAUTION
Do not use boiling water because it may damage the plastic parts. In addition, never use a
sharp or metallic instrument to remove frost as it may damage the cooling coils and will void
the warranty. We recommend using the plastic scraper provided with your unit.
Remove the frozen food from the appliance and place it in a cooler to protect the food.
Set the thermostat dial to “OFF’ and then wait 30-40 minutes.
Keep drip tray in place. Defrosting usually takes a few hours.
After defrosting, empty water from drip tray and return the thermostat dial to the desired position.
Using Your Ice Cube Trays
For your ice requirements, fill approximately 3/4 of the tray after washing it.
• The ice cube tray need to be set on the floor of the freezer to freeze properly.
• To eject the ice cubes from the trays, place over the ice bucket upside down and twist slightly.
Evaporator Drip Tray
• The drip tray is located on the top of the compressor in the rear of the unit. It can be easily removed by
pulling the handle forward. When placing it on drip tray hole insert it horizontally as shown below.
• If not properly installed, defrosted water can enter into the compressor causing damage.
11
, Is';