ASA Electronics VR100 - Manual (Page 3)

most useful when travelling in a new area where you are not familiar with the
local stations.
(g) STATION PRE-SET MEMORIES
To set any of the 6 pre-set memories, use the following procedure:
1. Turn the unit on and select the AMI band.
2. Select the first station to be pre-set using the Manual Tuning CD &® .
3. Press the pre-set button to be set and continue to hold the button in. The
volume will be muted for approximately 2 seconds and then return. The
station Is now set Into that pre-set button. To recall that station, press the
button momentarily.
4. Repeat the above procedure for the remaining 5 pre-sets on the band.
5. Select the AM2 band and enter 6 FM memories using the same procedure as
above. In similar fashion, enter 6 pre-set memories on the FM1 ,FM2,FM3
Band.
0 LIQUID CRYSTAL DISPLAY PANEL
The Liquid Crystal Display(LCD) panel displays the frequency, time and
activated functions.
Note: It Is a characteristic of LCD panels that If subjected to cold temperatures
for an extended period of time, they \Anll take longer to Illuminate than under
normal conditions. In addition, the visibility of the numbers on the LCD may
sightly decrease. The LCD read-out will return to normal when the temperature
Increases to a normal range.
© CASSETTE DOOR
Hold the cassette with the exposed tape edge to the right and Insert Into the
cassette door. Depress fully until the cassette Is engaged and begins playing.
Note: Observe cassette operation Cautions in Care and Maintenance section of
this manual.
© FAST-FORWARD/EJECT BUTTON
This button performs two functions. To eject a cassette, simply press the button
fully In and release. The cassette will eject and radio operation wnll resume. To
fast-forward the tape, depress the button half-way in to the locked position. To
stop fast-forward and resume normal tape playback, depress the button slightly
and release. Do not press fully In or the cassette \MII be ejected.
© TIME/FREQUENCY SELECTOR (CLK)
During radio operation, push this button to call the time display on the
incorporated quartz clock. Pressing the button again \will return to frequency
display, or It will automatically return after approximately 5 seconds.
SETTING CLOCK
1. Switch vehicle ignition "on" and radio "off' (time display will show on LCD
Panel)
2. Press and hold the Time /Frequency Selector(CLK). at the same time. Press
the Down Tuning button @ to adjust the hours , then the Up Tuning
button © to adjust the minutes.
3. After setting the correct time , release the Time/Frequency Selector.