Chicago Electric MIG-100 91124 - Manual (Page 9)

Page 9 SKU 91124
9. Turn the Torch Handle Nozzle counterclockwise and pull to remove.
10. Turn the Contact Tip counterclockwise and remove.
11. Lay the Torch Sheath out in a straight line so that the wire moves through it easily.
Warning: The following steps require applying power to the welder. Do not touch any-
thing with the Torch Handle or an arc may be ignited.
12. Plug the Power Cord into its electrical outlet, press the Current Switch to Max., and turn
the welder ON.
13. Lift the Torch Handle and continue pressing the Trigger until the wire feeds through two
inches.
If the wire does not feed, view the Wire Feed Unit and see if the wire is being pushed.
If it is not, turn the welder OFF and add more tension to the Wire Feed Adjusting
Spring (36).
14. Turn the welder ON again and press the Trigger.
15. Once the wire is exposed, turn the welder OFF and unplug it.
16. Slide the Contact Tip over the wire and screw it into Torch Handle.
17. Replace the Nozzle and cut off any excess wire over two inches.
18. Secure the Cover.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR
SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE
BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER
REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING
OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.