Concord Camera 3103 - Manual (Page 61)

57
Reference
- Install the USB driver before
you connect the camera to a
connecting to a computer with
Cannot transfer images after
USB cable.
PC.
- Turn on the camera.
- USB driver is not installed.
- Camera is turned off.
If the low-battery indicator
appears on the camera LCD
screen, replace batteries with a
- Turn the mode dial to Auto
mode or Manual mode.
- Wait until the flash finishes
- Delete images you no longer
This camera can not display
Set the flash to any other mode
appropriate setting, NTSC or
- Please use the attached video
cable to connect the camera
- Set the video system to the
Recorded images are not
Images are not displayed.
The flash doesn't fire.
Image not showing on TV.
saved in memory
full set of new ones.
non-DCF images.
except Off.
to the TV correctly.
PAL for your TV
completed.
the save operation has
Camera powers off before
A memory card with non-DCF
images recorded with another
camera is loaded in the
camera.
The flash mode is set to Off.
- There is a problem with the
camera-TV connection.
- Incorrect video system
setting.
Images are blurry or unfocused.
Image does not record when
the shutter button is pressed.
- The camera was moving
focus range.
- The subject was out of
when you took images.
charging.
need.
- Memory is full.
- Flash is charging.
Playback mode.
- The mode dial is set to
Problem Cause Action
- Press the shutter button halfway
locked, the auto focus mark turns
and align the auto focus mark on
the subject. When the focus is
green. Further depress the
shutter button to take the picture.
- Hold the camera steady when
80cm between the camera
shooting.
- Be sure that there is at least
lens and the subject.