Crown Equipment PW 3000 Series - Manual (Page 12)

Daily Safety Check
21 Daily Safety Check
CHECK YOUR TRUCK BEFORE STARTING WORK
You must make sure your truck is safe to use.
1. Walk around your truck and check it over.
• Check to make sure the battery is charged, water level
is OK and vent caps are in place. Don't use an open
flame to check the battery.
• Make certain the battery retainers on both sides of the
truck are properly installed.
• See that all wheels are in good condition.
• Clean the twist grips.
• Check that both forks are straight and not cracked
or badly worn.
• See that the load backrest is in place and fastened, if
your truck has that option.
• Look under the truck for signs of hydraulic leaks.
• Try the horn.
• Make sure the power disconnect works.
• Check that all controls work smoothly.
Daily Safety Check 22
2. Test drive your truck in an uncongested area.
• Try all the hydraulic functions.
• Check the steering.
• Operate the truck slowly in both directions.
• Operate through the full speed range in both forward
and reverse.
• Check braking distance in forward and reverse. Load
size and floor conditions can affect these distances.
• Know the distance it takes to stop before you start
working. If the braking distance is too long to stop
safely, don't use the truck.
If anything doesn't look, work or feel right, don't use the
truck. Report the problem to your supervisor.
You can get checklist forms from your Crown dealer
(part no. OF-3772). Used properly, this checklist can alert
service people to needed repairs.