Casio EXILIM EX-Z4U - Manual (Page 29)

GETTING READY
29
3. Turn off the camera.
4. Set the camera onto
the USB cradle.
• Do not place the camera
onto the USB cradle
while it is turned on.
• The [CHARGE] lamp
on the USB cradle
should turn red,
indicating that charging
has started. When
charging is complete,
the [CHARGE] lamp
will turn green.
5. After charging is complete, remove the
camera from the USB cradle.
IMPORTANT!
• It takes about two hours to achieve a full charge.
Actual charging time depends on current battery
capacity and charging conditions.
• Use only the USB cradle (CA-21A) that comes with
the camera, the optionally available USB cradle (CA-
21), or the optionally available charger unit (BC-10L)
to charge the special NP-20 rechargeable lithium ion
battery. Never use any other charging device.
• Use only the bundled AC adaptor. Never use any
other type of AC adaptor. Do not use optionally
available AD-C40, AD-C620 and AD-C630 AC
adaptors with this camera.
• Make sure that the camera connector of the USB
cradle is securely inserted into the camera’s
connector as far as it will go.
• The [CHARGE] lamp may remain amber colored and
the charge operation may not start right away if you
try to charge immediately after using the camera
(which causes battery to become warm) or when it is
too hot or too cold where you are performing the
charge operation. If this happens, simply wait until
the battery reaches normal temperature. The
[CHARGE] lamp will turn red and charging will start
when the battery temperature returns to the
allowable charging temperature range.
PHOTO
CHARGE
USB
DISP
MENU
SET
REC PLAY
[CHARGE] lamp