Evenflo Symphony 65 - Manual (Page 28)

52
General Information
53
Using the Quick Connectors
General
buckle storage buckle storage
When the SureLatch lower an-
chor connector assembly is in
the
forward-facing belt path,
snap each SureLatch connec-
tor onto a
forward D-ring for
storage.
When the SureLatch lower
anchor connector assembly is
in the
rear-facing belt path,
snap each SureLatch con-
nector onto a
rear D-ring for
storage.
buckle storage buckle storage
To remove the SureLatch con-
nector from a vehicle lower
anchor bar or from its storage
D-ring, press the red Release
Button.
Release Button
When the Quick Connector lower anchor connector assembly
is in the
rear facing or forward-facing belt path, snap each
Quick Connector onto a D-ring in the front, as shown.
buckle storage buckle storage
buckle storage buckle storage
To remove the Quick Con-
nector from a vehicle lower
anchor bar or from its storage
D-ring, pull the red Release
Strap.
Release Strap
Using the SureLatch Connectors
To adjust, squeeze the
headrest adjust lever, as
shown, while sliding the
headrest up or down to
the desired position.
Adjusting the Headrest
Headrest Adjust Lever
Squeeze the recline lever at
the bottom of the child
restraint, as shown, and
select the desired recline
position.
IMPORTANT: After adjusting
the recline position, rock the
child restraint back and forth
to make sure it is securely
locked in the desired position.
buckle storage
Recline Lever
Adjusting the Recline Position
This child restraint can be adjusted into three positions.
CORRECT RECLINE POSITIONING
• In rear-facing position: Use Recline Position #1 ONLY.
• In forward-facing position when child is secured with
harness straps: Use Recline Position #2 for children who
weigh 10 to 18 kg (22 to 40 lbs); use
Recline Position
#3 for children who weigh 10 to 29.4 kg (22 to 65 lbs).
• In booster mode: Use Recline Position #3 ONLY.
Not available on all models.
Not available on all models.