Operation – MTD 24695U User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CARRIAGE
BOLT (A)
FIGURE 4.
3.
Place the upper handle (D) over the lower handle,
lining up the holes. Secure with carriage bolts (A)
and hand knobs (B). See figure 4.
4.
Slip end of directional discharge (E) over chute
opening. Secure in position with hex sems bolt
(C). See figure 5.
FIGURE 5.
OPERATION
BEFORE STARTING ENGINE
Service engine with gas and oil. See engine manual
packed with leaf blower for complete instructions
Nfor care and maintenance of engine. READ DIREC
TIONS CAREFULLY.
TO START ENGINE
1. Move throttle to start position.
2.
Pull starter rope once with quick, full stroke.
Move hand throttle to fast position and pull
starter rope again.
3.
When engine starts, rriove throttle to "RUN"
position until engine warms up.
TO STOP ENGINE
Move throttle control lever to "OFF" position.