MTD 114-074-000 - Manual (Page 6)

a. Hook the “Z” end of the cable into notch
provided in the biade controi handle. See
—figures.
b. Push release lever (see figure 12), then
squeeze blade control handle against up­
per handle.
c. Release the blade control handle, unhook
the cable from the notch and hook it into
the hole in the blade control handle.
FIGURE 6.
FIGURE 7.
8. Remove the engine shroud if the unit is so
equipped. Replace it after attaching the throt­
tle control cable.
9. Place the throttle control lever on the handle
in “Fast” position.
10.-- Push the throttle control lever on the engine
to the full open position (as far toward the out­
side of the unit as it will go) as shown in figure
------7.
11. Hook the “Z” end of the throttle control cable
into the hole in the control lever on the
engine.
12. Remove the screw on the cable clamp shown
in figure 7. Slip the control casing under the
clamp. With the throttle lever on the engine
still in the full open position, replace and
tighten the screw to secure the throttle con­
trol cable.
13. Secure throttle control cable and blade
brake/clutch cable to upper and lower handles
----- with cable ties (E) provided. See figure 8.
FIGURE 8.