Unpack carton & install handle (see, Install reverse rod (see fig. 2), Install depth stake assembly – Poulan HDF550H User Manual
Page 6: See fig. 3), Handle height, Tilling width, Tine operation, Assembly
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
UNPACK CARTON & INSTALL HANDLE (See
Fig. 2.)
A
CAUTION:
Be careful of exposed
staples when handling or disposing of
cartoning material.
IMPORTANT:
WHEN UNPACKING AND ASSEMBLING
TILLER, BE CAREFUL NOT TO STRETCH OR KINK
CABLE(S).
« Cut cable ties securing handies.
® Slowly lift handle assembly up and align handle holes
with handle panel hole and slot.
® Loosely assemble hardware as shown. Be sure the
shorter (3/4" long) hex bolt is assembled in lower hole
of handle. Repeat for opposite side. Tighten all
hardware securely.
® Cut cable ties securing tiller to skid and remove tiller
from skid.
INSTALL REVERSE ROD (See Fig. 2)
*
Secure upper reverse rod to lower reverse rod using
clevis pin. Secure with cotter pin.
INSTALL DEPTH STAKE ASSEMBLY
(See Fig. 3)
•
Loosen nut “A”.
« Insert stake support between engine bracket halves
with stake spring down.
® Bolt stake support to engine brackets with bolts, lock
washers and nuts. Tighten securely. Tighten nut “A”.
« Depth stake must move freely. If it does not, loosen
support bolt.
HANDLE HEIGHT
» Handle height may be adjusted to better suit operator.
(See “HANDLE HEIGHT” In the Service and Adjust*
ments section of this manual).
TILLING WIDTH
» Tilling width may be adjusted to better handle your
tilling conditions (See “TINE ARRANGEMENT” in the
Service and Adjustments section of this manual).
TINE OPERATION
» Check tine operation before first use. (See “TINE
OPERATION CHECK” in the Service and Adjustments
section of this manual).