Dumping of sweeper, Lubrication, Figure 3 – MTD TMO-285A User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Figure 1
DUMPING OF SWEEPER
Your sweeper can be dumped very easily without
removing or disconnecting a part. Simply lift the
hopper as shown and swing it over the sweeper
and dump. See figure 2.
A
CAUTION
If you are planning on dumping your
Sweeper near a fire use care not to
get too close, the brushes can be
destroyed
by
excessive
heat
or
flame.
LUBRICATION
The
bearings
in
your
Sweeper
have
been
prelubricated
at
the
factory,
however,
it
is
recommended that a few drops of light oil should
be added to the impeller and brush shaft bearings
twice a year. Also, the wheels and pinions should
be removed, the axles cleaned and an even coat of
light oil applied. See figure 3.
Figure 3
Figure 2