beautypg.com

Handle storage, Off-season storage – MTD 111-010R000 User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Service

air cleaner

every 25 hours under normal conditions.

Clean every few hours under extremely dusty conditions. Poor

•s engine performance and flooding usually indicates that the

air cleaner should be serviced. To service the air cleaner,

refer to the separate engine manual packed with your unit.

The

spark plug

should be cleaned and the gap reset once

a season. Spark plug replacement is recommended at the

start of each mowing season; check engine manual for cor­

rect plug type and gap specifications.

Clean the engine

regularly with a cloth or brush. Keep the

cooling system (blower housing area) clean to permit proper

air circulation which is essential to engine performance and

life. Be certain to remove all grass, dirt and combustible debris

from muffler area.

NOTE: When storing any type of power equipment in an un-
ventiiated or metai storage shed, care shouid be taken to rust­

proof the equipment. Using a light oil or silicone, coat the

equipment, especially cables and all moving parts.

HANDLE STORAGE

You can fold your mower handle for storage as shown in

figure 10. Loosen the hand knobs on both sides of the handle.

Fold upper handle as shown.

NOTE: When folding handle for storage or transportation, be
careful not to bend or kink the brake cable.

OFF-SEASON STORAGE

The following steps should be taken to prepare lawn mower

for storage.

1. Clean and lubricate mower thoroughly as described in

the lubrication instructions.

2. Refer to engine manual for correct engine storage in­

structions.

3. Coat mower’s cutting blade with chassis grease to pre­

vent rusting.

4. Store mower in a dry, clean area.

NOTE:

The use of any accessory on this Rotary Mower other than those manufactured by the mower

manufacturer is not recommended.

A

WARNING: To reduce the risk of injury, do not operate mower unless rear trailing shield
and guard are in their proper place.