MTD 191-768 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
11.
Remove clevis pin from lift bar. Attach wire
hook to one end of each spring. Attach wire
hook end of spring on the snow thrower arm
with hole and the other end of spring on the
lift bar.
14.
Attach belt keeper on inside of grille with
large flat washer, lockwasherand bolt provided.
DO NOT TIGHTEN. Be sure belt keeper is in
such a position that it will not allow the belt
to come off the pulley.
12.
Remove lift hitch rod from lift handle. Insert
oblong spacer between lift handle and hitch
lift rod. Attach with clevis pin and cotter
hairpin. (Clevis pin provided is longer than
the one on the tractor.)
15.
Be sure the snow thrower is disengaged. At
tach belt to front P.T.O. sheave. Tighten
belt keeper.
13.
Attach lift rod to snow thrower and oblong
spacer. Use cotter hairpin to attach lift rod
to spacer.
16. Attach elbow assembly to stack control. Hook
loop end of cable over the stud on the elbow.
WHEN ORDERING REPLACEMENT PARTS, PLEASE ORDER FROM:
HABAN MANUFACTURING COMPANY
MOUND AND MARQUETTE STREET
RACINE, WISCONSIN 53404