MTD 242-662-000 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Upper
—Handle
Hex Bolt s
Hex Loc i
Nuts
Low sr
Handle
FIGURE 5.
Air Duct
Assembly
FIGURE 7.
ATTACHING THE UPPER HANDLE (Hardware C)
Place the upper handle in position over lower handle.
Fasten with four hex bolts 1-3/4" long and hex lock
-nuts. See figure 5. Two 7/16" wrenches are required.
ATTACHING THE AIR DUCT ASSEMBLY
(Hardware D)
1. Place the tabs on the air duct assembly into the
--------slots in the frame as shown in figure 6. Raise the
air duct into position.
Secure air duct with hand knob and cupped
washer. Cupped side of washer must be against
■ the air duct. See figure 7.
ATTACHING THE BAG (Hardware E)
1.
Place the stud pins in holes in upper handle
(head of pins go to the inside of handle). Secure
pins with push-on speed nuts by holding speed
nut with box wrench and tapping pin with ham-
------ mer. See figure 8.