Optionai. chute deflector, Attaching chute deflector to mower – MTD 113-410A000 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPTIONAI. CHUTE DEFLECTOR
Tab
Push
Nut
If your mower is equipped with the optional chute
deflector, assemble as follows.
1. Slide the rod into the upper edge of the chute
deflector so the welded tab on the rod is toward
the left side of the chute deflector. When assem
bled correctly, the rod will extend further to the left
------ side than the right side. See figure A.
2. Slide the push nut onto the right side of the rod to
secure.
ATTACHING CHUTE DEFLECTOR TO MOWER
Lift the rear discharge door on the mower. Place the
ends of the rod into the slots in the handle bracket
-assemblies. See figure B. Release the rear discharge
door.
To remove the chute deflector, lift the rear discharge
door on the mower. Lift the chute deflector up, out of
the slots in the handle bracket assemblies. Release
the rear discharge door.
12