Operation, Note, Before starting – MTD 219-405-000 User Manual
Page 8: To stop engine, To start engine, Warning, How to use your tiller, Operation how to use your tiller
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
-NOTE
Engine is shipped without oil.
BEFORE STARTING
1. Before operating tiller for the first time or if ines
have been removed and reassembled for any
reason, check to be certain the tines are as ;em-
bled correctly. The sharp edge of the tines i nust
enter the soil first as shown in figure 13. (Fi gure
13 illustrates the left hand tines, viewed from the
left hand side of the tiller. Right hand tines rotate
in the same direction as the left hand tines )
3. Stand at side of tiller. Grasp the starter handle and
pull out rapidly. Return it slowly to the engine.
Repeat as necessary.
4. After engine starts, move choke lever gradually to
OFF position.
Refer to engine manual for additional engine infor
mation.
TO STOP ENGINE
1. Move throttle control to OFF position.
2. Disconnect spark plug wire and ground to prevent
accidentally starting while equipment is un
attended.
FIGURE 13.
2. Fill crankcase with oil as instructed in the sepi irate
engine manual packed with your unit.
3. Fill fuel tank with clean, fresh, lead-free, low- lead
or regular grade leaded gasoline.
TO START ENGINE
Ai
WARNING
BE SURE NO ONE IS STANDING IN
FRONT OF THE TILLER WHILE THE
ENGINE IS RUNNING OR BEING
STARTED.
1. Place the throttle control lever in START pos tion.
2. Move choke lever to CHOKE position.
NOTE
A warm engine may not require
choking.
HOW TO USE YOUR TILLER
A
t WARNING i
When operating the tiller for the
first time, use the depth bar setting
that gives IV
2
Inches of tilling depth
(second hole from the top). Refer
to figure 14. Use slow speed only.
Tilling depth is controlled by the depth bar which can
be adjusted to five different settings. See figure 14. Ad
just the side shields as shown in figure 15, as you ad
just the depth bar. Be certain spark plug wire is
disconnected and grounded against the engine.
1. When using the tiller for the first time, use the sec
ond adjustment hole from the top (
1
V
2
" of tilling
depth). See figure 14.