Sections: unpacking, To remove unit from carton, Tools required for assembly – MTD 060 Series User Manual
Page 8: Disconnect spark plug wire, Section 7: assembly instructions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTIONS: UNPACKING
TO REMOVE UNIT FROM CARTON
• Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open.
• Remove loose parts if included with unit (i.e., operator’s manual, etc.).
• Cut along dotted lines and lay carton down flat.
• Remove packing material.
• Slide unit out of carton. Check carton thoroughly for loose parts.
TOOLS REQUIRED FOR ASSEMBLY
(1) 1/2" Wrench
(2) 9/16" Wrenches
(1) Phillips Screwdriver
(1) 3/4" or Adjustable Wrench
(Two 6" Adjustable Wrenches may be used instead of the above.)
DISCONNECT SPARK PLUG WIRE
Before setting up your lawn mower, disconnect the spark plug wire from the spark plug, and ground it against
the engine. See Figure 3.
SECTION 7: ASSEMBLY INSTRUCTIONS
IMPORTANT:
This unit is shipped WITHOUT GASOLINE or OIL. After assembly, service engine with
gasoline and oil as instructed in the separate engine manual packed with your unit.