Mr. Coffee GB Series - Manual (Page 10)

Using the Brew Strength Selector
If you would like a more full-flavored coffee, press the BREW STRENGTH
selector button once before you begin brewing. The STRONG light will turn
on when it is set.
Figure 2
Brewing Coffee Now: Using Fresh Beans
1. Press the lid release button in front of the coffeemaker to open its lid.
Remove the grinding chamber assembly {see #1. page 5). Insert a MR.
COFFEE® brand 8-12 cup paper or permanent filter into the filter basket.
For best results, wet the edges of the paper filter and press it against the
sides of the filter basket to prevent filter collapse. Replace the filter basket
and the removable grinding chamber assembly.
2. Remove the grinding
chamber lid and add the
desired amount of coffee
beans to the grinding
chamber according to the
Suggested Coffee
Measurement Chart on page
8 . Replace the grinding
chamber lid. See Figure 2.
3. Fill the decanter with water
to the desired capacity
(1 cup equals 5 ounces).
4. Pour the water Into the
water reservoir. Close the
lid and place the empty
decanter onto the warming
plate.
5. Press the SELECT button
once to set the coffeemaker
to GRIND & BREW.
The GRIND & BREW light
will turn on to signal that
the coffeemaker is
grinding (the grinder
operates for 45 seconds).
See Figure 3. You may
select the brew strength at
Figures.
Note: For your safety, If the lid Is opened during the grind or brew
cycle, the coffeemaker will turn itself off. If this happens, you must
restart the grind cycle by pressing the SELECT button once or restart
the brew cycle by pressing the SELECT button twice.