Operation, Adjustments, Warning – MTD 241-688A User Manual
Page 6: Operation adjustments
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FIGURE?
PLUG
OPERATION
BEFORE STARTING ENGINE
1.
Remove oil fill plug and fill crankcase with 1-1/4
pints S.A.E. No. 30 oil. See figure 7.
2.
Clean fuel tank with good grade regular, clean,
fresh
gasoline.
DO
NOT
MIX
OIL
WITH
GASOLINE.
FOR
COMPLETE
ENGINE
INFORMATION, READ ENGINE INSTRUCTION
BOOKLET BEFORE STARTING OR OPERAT
ING.
TO START ENGINE
1. Move throttle to start position.
2. Pull starter rope once with quick, full stroke.
Move hand throttle to fast position and p
starter rope again. See figure 8.
3.
When engine starts, move throttle to "RUN
position until engine warms up.
TO STOP ENGINE
Move throttle control lever to "OFF" position.
FIGURES
ADJUSTMENTS
WING NUTS ON SiOL
FIGURES
^ WARNING
\
Do Not make this adjustment or any
adjustment with the engine running.
Stop the engine, disconnect the spark
plug wire and ground plug wire to
engine block.
TWO-WAY AIR DISCHARGE
Your Leaf Blower is equipped with an adjusv.
chute deflector. Simply loosen two wing nuts at
side of deflector to raise or lower. You also can
direct the air by loosening the wing nut on top and
moving the deflector from side to side. See figure 9.