Generac 7500 - Manual (Page 4)

K now Y our
m
GfflEEATOR
Generac Portable Products 7500EXL Extended Life Generator
KNOW YOUR GENERATOR
Read this ow ner’s m anual and safety rules before operating your generator.
Compare the ilfustrations with your generator to familiarize yourself with the iocations of various controls and
adjustments. Save this manual for future reference.
12 Volt DC Receptacle — Use this receptacle with
battery charge cables to charge a 12 Volt battery.
120 Volt AC, 20 Am p Receptacles — May be used to
supply electrical power for the operation of 120 Volt
AC, single phase, 60 Hz electrical lighting, appliance,
tool and motor loads.
120 Volt AC, 30 Am p Locking Receptacle — May be
used to supply electrical power for the operation of
120 Volt AC, 30 Amp, single phase, 60 Hz electrical
lighting, appliance, tool and motor loads.
120/240 Volt AC, 30 Am p Locking Receptacie —
May be used to supply electrical power for the
operation of 120 and/or 240 Volt AC, 30 Amp, single
phase, 60 Hz electrical lighting, appliance, tool and
motor loads.
240 Volt AC, 50 Am p Receptacle — May be used to
supply electrical power for the operation of 240 Volt
AC, 50 Amp, single phase, 60 Hz electrical loads.
Choke Lever — Used when starting a cold engine.
Circuit Breakers (AC) — Each receptacle is provided
with a "push to reset" circuit breaker to protect the
generator against electrical overload.
Electric Start Sw itch — Pressed to start the engine.
Grounding W ing Nut — Use this connection to
properly ground the generator.
Idle Control Sw itch — The idle control runs the
engine at normal (high) speeds when there is a load
present and runs the engine at idle (low) speeds when
a load is not present.
Recoil Starter — Used as an alternate means of
starting the engine.
Run/Stop Sw itch — Must be in “Run” position to start
engine. Set to “Stop” to stop a running engine.
Spark Arrestor Muffier — Exhaust muffler lowers
engine noise and is equipped with a spark arrestor
screen.