1 ( h ii .i'l. i – Poulan 169482 User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Worn, bent or
loose biacie.
Mower deck not level.
iH‘, |i
,1
j ■ , o ita«'n If (if r .flower
!' 1 ( H
II .I'l. I
'in
I - I ,|'v I k
1
. Ill nr Ifl-n tuildljp ' I
(J-
I
ii I 11 li i ""1 lendieK
a
i
I
1, Replac
«blade. Tights
n blade
bolt.
h;
power
deck,
ondersicie
of mo wer
housing.
I 4. Repfac
1 5, Cloan 1
:e
blade
mandre
around mandre!: s
to open vent
holes.
rotate
3. Frozen idler pulley.
rsu£.«H yicluc mcinutcsi.
i 2. Replace mower drive belt.
• f' f |(’l 1 (. (Ik '
a. Rc|jtacfe bsaÜK iftctriUiel.
Poor grass discharge
1.
Engine speed too slow.
2.
Travel speed too fast.
3.
Wet grass.
4.
Mower deck not level.
5.
Low/uneven tire air pressure.
6.
Worn, bent or loose blade.
7.
Buildup of grass, leaves and trash under mower.
8.
Mower drive belt worn.
9.
Blades improperly in-stalled.
10.
Improper blades used.
11.
Clogged mower deck vent holes from buildup of
grass, leaves, and trash around mandrels.
1.
Place throttle control In “FAST” position.
2.
Shift to slower speed.
3.
Allow grass to dry before mowing.
4.
Level mower deck,
5.
Check tires tor proper air pressure.
6.
Replace/sharpen blade. Tighten blade bolt.
7.
Clean underside of mower housing.
8.
Replace mower drive belt.
9.
Reinstall blades sharp edge down.
10.
Replace with blades listed in this manual.
11.
Clean around mandrels to open vent holes.
Headiight(s) not working
(if so equipped)
1.
Switch is “OFF”.
2.
Bulb(s) burned out.
3.
Faulty light switch.
4.
Loose or damaged wiring.
5.
Blown fuse.
1.
Turn switch “ON".
2.
Replace bu!b(s).
3.
Check/replace light switch.
4.
Check wiring and connections.
5.
Replace fuse.
Battery will not charge
1.
Bad battery cell(s).
2.
Poor cable connections.
3.
Faulty regulator (if so equipped).
4.
Faulty alternator.
1.
Replace battery.
2.
Check/clean all connections.
3.
Replace regulator.
4.
Replace alternator.
Loss of drive
1.
Freewheel control in “disengagecf position,
2.
Motion drive belt worn, damaged, or broken.
3.
Air
trapped in transmission during shipment
or servicing.
1.
Place freewheel control in “engaged” position.
2.
Replace motion drive belt.
3.
Purge transmission.
Engine “backfires”
when turning engine
“OFF”
1. Engine throttle control not set at "SLOW”
position for 30 seconds before stopping engine.
1. Move throttle control to “SLOW” position and allow
to idle for 30 seconds before stopping engine.