MTD 192-766 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY INSTRUCTiONS FOR BOOSTER SPRINGS 732-246
(USED WITH TILLER ATTACHMENTS 192-766 and 193-966)
Booster springs may be used with any accessories which can be attached at the rear of the tractor.
NOTE: Booster springs cannot be used when using the 42'' mowing deck attachment.
1. Remove any attachment which may be on the tractor,
2. Pull the lift lever all the way back to disengaged position,
3. Remove cotter pin, flat washer and pull rod from clevis pin at location shown in figure 1.
4. Hook one end of spring on clevis pin as shown in figure 1.
5. Place the pull rod, flat washer and cotter pin back on the clevis pin as shown in figure 1.
6. With a screwdriver or tube (as shown in figure 2), extend spring forward and hook over the welded clevis pin
on the frame. (See figure 2)
7. Secure the spring with a flat washer (310-7387) and a cotter pin (714-117), which is provided with the springs.
(See figure 1)
COTTER
PIN
714-117
WASHER
310-7387
CLEVIS PIN
COTTER PIN
TUBE
Figure 1
Figure 2