beautypg.com

To transpinr, Before starting engine, Fill engine with oil (see fig. 7) – Poulan 163659 User Manual

Page 9: To start engine (see fig. 8), Operation, Ado gasoline

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

OPERATION

TO TRANSPinr

A

CAUTIOH: Before isfttrsg or transport­
ing, allow fillet engine and muffler to
cool. Disconnect spark plug wire. Drain
gasoline from fuel tank.

AROUND THE YARD

Tip depth stake forward until it is held by the stake

spring.

Push tiller handles down, raising tines off the ground.

Push or pull tiller to desired location.

AROUND TOWN

Disconnect spark plug wire.

Drain fuel tank.

Transport in upright position to prevent oil leakage.

BEFORE STARTING ENGINE

IMPORTANT: BE VERY CAREFUL NOT TO ALLOW DIRT

TO ENTER THE ENGINE WHEN CHECKING OR ADDING

OIL

OR

FUEL. USE CLEAN OIL AND FUEL AND STORE

IN APPROVED, CLEAN, COVERED CONTAINERS. USE

CLEAN FILL FUNNELS.

FILL ENGINE WITH OIL (See Fig. 7)

With engine level, remove engine oil filler plug.

Fill engine with oil to point of overflowing. For approxi­

mate capacity see “PRODUCT SPECIFICATIONS” on
page 3 of this manual.

Tilt tiller back on its wheels and then re-level.

With engine level, refill to point of overflowing if neces­

sary. Replace oil filler plug.

For cold weather operation you should change oil for

easier starting (See “OIL VISCOSITY CHART” in the
Customer Responsibilities section of this manual).

To change engine oil, see the Customer Responsibili­

ties section of this manual.

ADO GASOLINE

fuel tank.

ill ii- 'L'n

d lead uxidf

llsi

of ie

dep<

;h, dean, regular unleaded

I 1 . 1 W l l i W I P . » ' ^ ( o r t l U t

a id "I nu' r V' e M' )

ATING IN TEMPERATURES

! | « 1 t A N W l f l T F P G R A D t

. t 1 . 0 . • [ » » f i | D W t A l H E R

mpmnti ,

L (

L E G ) A / j ( ( f e c ) U f M . r ^

(.r- ,ui ifi. ro hto r III ,Ur

‘ I

m

H r i N f

WARNING: Experience indicates that alcohol blended
fuels (called gasohol or using ethanol or methanol) can
attract moisture which leads to separation and formation of
acids during storage. Acidic gas can damage the fuel
system of an engine while in storage. To avoid engine
problems, the fuel system should be emptied before
storage of 30 days or longer. Drain the gas tank, start the
engine and let it run until the fuel lines and carburetor are
empty. Use fresh fuel next season. See Storage section
of this manual for additional information. Never use engine
or carburetor cleaner products inthe fuel tank or permanent
damage may occur.

CAUTION: Fill to within 1/2 inch of top
of fuel tank to prevent spills and to
allow for fuel expansion. If gasoline is

accidentally

spilled,

move

machine

away from area of spill. Avoid creating
any source of ignition until gasoline
vapors have disappeared.

Do not overfill. Wipe off any spilled oil
or fuel. Do not store, spill or use gaso­
line near an open flame.

TO START ENGINE (See Fig. 8)

CAUTION: Keep tine control in
position when starting engine.

‘OFF”

When starting engine for the first time or if engine has run
out of fuel, if wii! take extra pulls of the recoil starter to move
fuel from the tank to the engine.

Make sure spark plug wire is properly connected.

Place throttle control in “FAST” position.

Move choke

control

to full “CHOKE” position. Grasp

recoil

-Starter

handle

with

one hand and grasp tiller

handle with other hand. Pull rope out slowly until
engine reaches start of compression cycle (rope will
pull slightly harder at this point).

Pull recoil starter handle quickly. Do not let starter

handle snap back against starter. Repeat if necessary.

If engine fires but does not start, move choke control to

half choke position. Puli recoil starter handle until
engine starts.

When engine starts, slowly move choke control to

“RUN” position as engine warms up.

NOTE: A warm engine requires less choking to start.

Move throttle control to desired running position.

Allow engine to warm up for a few minutes before

engaging tines.

NOTE: If at a high altitude (3000 feet) or in cold tempera­

tures (below 32°F), the carburetor fuel mixture may need to
be adjusted for best engine performance. See “TO AD­
JUST CARBURETOR” in the Service and Adjustments
section of this manual.
NOTE: If engine does not start, see troubleshooting points.

This manual is related to the following products: