Maintenance and repair instructions – Ryobi HT920Dr User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MAINTENANCE AND REPAIR INSTRUCTIONS
Blade Screw Blade Screw
Blade Assembly
------------------------------------ Fig. 12--------------------------------------
7. Position new blade assembly over cam assembly,
then continue to manually slide blade assembly until
screw holes in blade assembly align with screw
holes in motor housing (Fig. 12).
NOTE: When properly aligned, blade assembly fits in
recessed slot in motor housing.
8. Replace blade screws. Tighten screws securely.
9. Replace blade cover. Reposition tabs on front of
blade cover under blade guard and lower rear of
blade cover into place (Fig. 13).
10. Replace blade cover screws (Fig. 13).
11. Tighten screws securely.
A
WARNING: Make sure blade cover is
replaced before connecting your hedge
trimmer to power supply. Failure to do so will
expose internal parts which could cause an
accident or electrical shock resulting in
serious injury.
NOTE: If binding occurs after replacing blade assembly,
repeat the steps above for reassembly.
11