Problem: the walking belt slows when walked on, Problem: the walking belt slips when walked on – NordicTrack EXP2000 NTTL11994 User Manual

Page 27

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

PROBLEM: The walking belt slows when walked on

SOLUTION:

a. Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in

length.

b. If the walking belt is overtightened, treadmill perfor

mance may decrease and the walking belt may be
come damaged. Remove the key and

UNPLUG THE

POWER CORD,

Using the alien wrench, turn both

rear roller adjustment bolts counterclockwise, 1/4 of a
turn. When the walking belt is properly tightened, you
should be able to lift each side of the walking belt 3 to

4 inches off the walking platform. Be careful to keep
the walking belt centered. Plug in the power cord, in
sert the key and run the treadmill for a few minutes.

Repeat until the walking belt is properly tightened.

c. If the walking belt still slows, please call our Customer Service Department, toll-free.

PROBLEM: The walking belt is off-center

SOLUTION:

If the walking belt has shifted to the left,

first remove

the key and

UNPLUG THE POWER CORD.

Using the

alien wrench, turn the left rear roller adjustment bolt clock
wise, and the right bolt counterclockwise, 1/4 of a turn each.

Be careful not to overtighten the walking belt. Plug in the
power cord, insert the key and run the treadmill for a few
minutes. Repeat until the walking belt is centered.

If the walking belt has shifted to the right,

first remove

the key and

UNPLUG THE POWER CORD.

Using the

alien wrench, turn the left rear roller adjustment bolt coun
terclockwise, and the right bolt clockwise, 1/4 of a turn
each. Be careful not to overtighten the walking belt. Plug
in the power cord, insert the key and run the treadmill for
a few minutes. Repeat until the walking belt is centered.

PROBLEM: The walking belt slips when walked on

SOLUTION:

a. If the walking belt slips when walked on, first remove the

key and

UNPLUG THE POWER CORD.

Using the alien

wrench, turn both rear roller adjustment bolts clockwise,

1/4 of a turn. When the walking belt is correctly tightened,

you should be able to lift each side of the walking belt 3 to
4 inches off the walking platform. Be careful to keep the
walking belt centered. Plug in the power cord, insert the
key and carefully walk on the treadmill for a few minutes.

Repeat until the walking belt is properly tightened.

PROBLEM: The incline of the treadmill does not change correctly or does not change when iFIT.com

CD’s and videos are played

SOLUTION:

a. With the key in the console, press one of the incline buttons.

While the incline is changing, re

move the key.

After a few seconds, re-insert the key. The treadmill will automatically rise to the

maximum incline level and then return to the minimum level. This will recalibrate the incline system.