Poulan 169087 User Manual

Page 20

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

s i F M V » r F A l v i f ;

< L -/i L •■i'', ¿liELl liC*^ S -'ir-r.

Adiust the mower while tractor is oarkec

uUC

■If

>PtCIHo-Ai lijNW seciion oi mis mare...........,

If tires are over or underinfiated, you will not properly

adjust your mower.

‘

! '

' “

’

' ' '

If I

H or ft iw r i'i ii‘ n af - I h >

' >i

A> t i .nidf'-'i.'i H h ih

‘J H> wc i, ntWjjUi.

im pni tr< tT! tcj'cm <-cu«r <■ -nvAei ;o uounJ
[t h,r ' /' U, d I'l t -its .| n UWi I litulobeiii-
.. ill c • I witliiii I/4‘ (4 etch oihet.

!i Jr

1^ n' I n CO* sary make adjustment on one

bi'!^ i! r ■(

»'i-r' iiL'

1.1 ii - ».a ,P - ,)i mt iv^-r lighten lift link adjusirnenf

iit)i OP mat ~!ic

•

lo lower one siae or mower, loosen lift link adjust

ment nut on that side.

NOTE: Three full turns of adjustment nut will change
mower height about 1/8".

•

Recheck measurements after adjusting.

BOTTOM EDGE
OF MOWER TO
GROUND

GROUND LINE

FIG. 19

FRONT-TO-BACK ADJUSTMENT (See Figs. 20 and 21)
IMPORTAMT; DECK MUST BE LEVEL SIDE-TO-SIDE. IF

THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS NEC
ESSARY, BE SURE TO ADJUST BOTH FRONT LINKS

EQUALLY SO MOWER VJILL STAY LEVEL SIDE-TO-SIDE.

? Mil 'h-

t.- I ' I'lMC .

!| Ih- n"

• •'

'll.}

Should be adjusted so that the front is approximately 1/8"'

to 1 / 2 " lower than the rear when the mower is in its high-

* I I j-Hlor

C’n*-Lt aulu' iui-rC '■I! i.qhi j< € rf tocto. HeE'Him tir-

iinm D iirerny ,r, front ard oM. (id ihf maiJi-l jt Of t-

u.rr. criM*- of Piowpr riot sii,q 'njw'i

Before mar ng an,f t'er‘'s:?ry c.Jjustments check

that bofn front Ini-i ore equal lo Icngtn Both link-

■r ould t‘( spDrr.,.rn3toiY i l - i / 8

If I'nW are no! equal in length .^d|Ubt ine lint io .^ame

length dS )thei link

To lower front of mower loosen nut “E” on both front

links an equal number of turns.

•

When distance “D” is 1/8" to 1/2" lower at front than

rear, tighten nuts “F” against trunnion on both front
links.

•

To raise front of mower, loosen nut “F” from trunnion

on both front links. Tighten nut “E” on both front links
an equal number of turns.

•

When distance “D” is 1/8" to 1/2“ lower at front than

rear, tighten nut “F” against trunnion on both front
links.

•

Recheck side-to-side adjustment.

■ ' i h