T i v / ' f – MTD 113-112 User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY FOR HANDLE MODELS 113-112 AND 113-122
1.
Remove the loose hardware from the assembly pack.
5
.
You will need a screwdriver and a 5/1 d" wrench,
either a socket as shown in figure
1
or an open end
6
.
wrench.
2.
Assemble the lower handle to the handle brackets as
7
.
shown in figure
2
.
3.
Secure the handle with cotter hairpins on both sides.
See figure 2.
8
.
4.
Place the handle panel over the lower handle and
fasten with the handle panel screw using a 5/16"
wrench. See figure 3.
Place the upper handle over the lower handle and line
up the holes as shown in figure 4.
Insert the curved head bolt from the inside and
tighten the knob by hand. See figure 4.
Place the throttle control in the handle panel and
assemble it with the two throttle screws using a
screwdriver. See figure 5.
Use the cable clip to fasten the throttle control wire
to the lower handle.
COTTER HAIRPINS
\
^ HANDLE PANEL
SCREW
M
T I v / ' F
CABUCLIP
BOLTS
FIGURE 1.
LOOSE HARDWARE AND TOOLS
FIGURE 2.
LOWER HANDLE ASSEMBLY
FIGURE 3.
HANDLE PANEL ASSEMBLY
FIGURE 4.
UPPER HANDLE ASSEMBLY
FIGURE 5.
THROTTLE CONTROL ASSEMBLY