Maintenance – Ryobi CS30 RY30923 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MAINTENANCE
MAINTENANCE
STRING REPLACEMENT
See Figures 26 - 28.
u Stop the engine and disconnect the spark plug wire. Hoid
the string head and turn the spooi retainer ciockwise to
remove.
■ Remove the spooi from the string head.
NOTE: Keep the spring attached to the spooi. Remove
any oid string remaining on the spool.
■ Cut one piece of trimmer iine 18 ft. iong.
■ Find themiddleofthestringsection.Loopthestring around
the hook in the center of the spool. Carefully wind the
string in the direction indicated on the top of the spool.
Nearing the end of the string, siide one end of the string
into each siot of the spooi. Do not overfili.
■ Replace the spool and the spool retainer. Refer to Spool
Replacement earlier in this manual.
CLEANING
THE
EXHAUST
PORT AND
MUFFLER
NOTE: Depending on the type of fuel used, the type and
amount of oil used, and/or your operating conditions, the
exhaust port, muffier, and/or spark arrestor screen may
become blocked with carbon deposits, if you notice a
power loss with your gas powered tooi, you may need to
remove these deposits to restore performance. We highiy
recommend that oniy quaiified service technicians perform
this service.
SPARK ARRESTOR
The spark arrestor must be cieaned or replaced every 25
hours or yearly to ensure proper performance of your prod
uct. Spark arrestors may be in different locations depending
on the model purchased. Please contact your nearest service
dealer for the location of the spark arrestor for your model.
REPLACING AND CLEANING AIR FILTER
See Figures 29 - 30.
For proper performance and long life, keep air filter clean.
■ Remove the air filter cover by pushing down on the latch
with your thumb while gently pulling on the cover.
■ Remove the air filter and clean it in warm soapy water.
Rinse and let dry completely.
■ Reinstall the air filter.
■ Replace the air filter cover by inserting the tabs on the
bottom of the cover into the slots on the air filter base;
push the cover up until it latches securely in place.
NOTE: For best performance, replace annually.
FUEL CAP
WARNING:
A leaking fuel cap is a fire hazard and must be replaced
immediately.
20
The fuel cap contains a non-serviceable filter and a check
valve. A clogged fuel filter will cause poor engine perfor
mance. If performance improves when the fuel cap is loos
ened, check valve may be faulty or filter clogged. Replace
fuel cap if required.
SPARK PLUG REPLACEMENT
This engine uses a Champion RCJ-6Y or NGK BPMR7A
spark plug with .025 in. electrode gap. Use an exact re
placement and replace annually.
STORING THE PRODUCT
■ Clean all foreign material from the product. Store idle unit
indoors in a dry, well-ventilated area that is inaccessible
to children. Keep away from corrosive agents such as
garden chemicals and de-icing salts.
■ Abide by all ISO and local regulations for the safe storage
and handling of gasoline.
When storing 1 month or longer:
■ Drain all fuel from tank into a container approved for
gasoline. Run engine until it stops.
AIR FILTER COVER
AIR FILTER
COVER
Fig. 30
21