Troy-Bilt 13096 - Manual (Page 34)

Section 7
Storage
When storing the unit for more than 30
days;
Add a gasoline stabilizer to fuel or move
unit outside and run for at least 10
minutes until engine stops from lack of
fuel.
Remove key from ignition.
Lower any mounted attachment to ground.
Place attachment/PTO switch into the
“OFF” position.
Allow engine to cool and clean dirt and
debris from unit. Thoroughly clean engine
cooling fins, engine flywheel screen and
transmission cooling fins.
Change engine oil.
Remove, clean and re-gap spark plug.
Reset gap according to specifications in
engine manual.
Re-install spark plug. Replace plug if badly
worn. Leave spark plug wire disconnected.
Clean or replace engine air filter if
necessary.
Check fuel filter and replace if necessary.
Check battery electrolyte level and add
distilled water only if necessary. Charge
battery once a month during storage.
Charge at 2 amps until specific gravity
reading is 1.265 to 1.275. Store battery at
20° F (7°C) to 50° F (10°C). Clean battery
posts and coat with petroleum jelly.
Apply rust preventative to surfaces subject
to corrosion. Apply touch-up paint to
surfaces where paint has chipped.
Apply a good grade of automotive wax to
hood.
Store unit in a dry, secure location.
34