Ariens 937 - Manual (Page 9)

Operation (Continued)
Starting
A
CAUTION: CD NOT iittempt to start your
oivgine at this tlmo. Thoroughly read this
ontire
awnsr's Manual nnd engino
mBnufactjrons operafting instructions first
NOTE: Try out each control kVitf>out running engine lo
see how (hey v/ark and whai thav do,
■OFF
-ON
Figure $; Engins Ignition
Engine Ign Шоп
A
A
WARNING: If equipment vibrates
sbODrinally disengage attachment, stop
engine Bit опое, and remcyve key. Abnormal
vibration Is a warning of trouble. Repair
enry damage before restarting unit.
CAUTION: Turn Key "OFF" and remove it
before
attempting any maintenance,
adjustment or leaving unit unetterKled.
To start engine, place Key in Switch and turrt rl dockwiso
to "RUN’ poaiiion
Choke
Pult choke Dontroi to ’Choke" posit ran When engine hea
started, open choke gradually
NOTE: A warm engine requires less choking than a cold
engine.
Primer Bulb
Push primer bulb two or three Itmes when engine is cold.
When temperaiurca are below -15 dagre-ез Fahranhart,
additional pnmrng may be needed.
Recoii Starter
A
WARNING; To provont discharge toward
operators' starting position, always turn
discharge chute straight ahead for starting
unit
Stano to right of unit. Grasp slarter handte and pull rope
out alovjly until it pulls harder this is oomprasaion stroke,
let rocc rewind slowly
Then pull rope with a rapid DoruinLious lull arm -itroke
Le( rope rewind sJowly,
IMPORTANT: DO NOT lei atarler handle snap against
bracKet.
10 Repeat above maiructions until engine starts. tRefer
angine manufacturers instructionsV
EEectrfi^ Starter (Optional ADCAseory)
Connect power cord to switch box first then plug other
and into 120 volt AC receptacle
Puah Siarter Bunon to crank engine
IMPORTANT; This olsdric starter is not equipped wrUi a
thermal cut-Dul swiich DO NOT crank ongrne for more
lhan a tetaJ erf 20 aecorrfe without Bttowmg electrk: starter
lo cool down for 10 minuies Failure to do (his can
severely damage elearic siertar.
When engine starts, release starier button and
discbrinecl power cord from rsoepiacle first, than from
switch box
A
CAUTION; DO NOT overload machine
capacity by attempting to claer snow at too
fast a rate.