Ariens 937 - Manual (Page 13)

Adjustments (Continued)
Scraper Blade i£ adiuatHoli* le romperefite for wear ana
to cormol auger iraction {вицчт pmpelF uniti.
Adjust зсгарзг biade equally t-i ti:|| lengih if machine
does not scrape eicanly or if rnacnme does not drive
ferv/ard properly
To adiuet aerane' blade, np unit boCK and real unit on
handlebar Loosen nula on carriage bolts along scraper
supporl 5F unit rk>es noi scrape cleanly, move anraper
blade ror^ard If unit does пЫ drive iorward and scrapor
blade mags, move эсгярет blade lo thie rear.
MOTE: Tighten nardware and tesi unit. Repeal
adjuslment as required until proper operaiion is oblainerJ
Engine B&tt
A
CAUTION: For proper bracing and engma
bell
engagement, with Clutr^b Bail
disengaged, there most be slack in cable
Tbere should ba 3>/le" to 1/4" extension of
cable spring when Clutch Ball
Is held
agBlnet handlebar
To nciust, turn nuts on upfjer r:able end until there ts the
proper SDtmg extension and lock m positron by locking
rmla egeinat bracket
Ben Alignment
When -eolacinq hells replace both bsita at lbs aeme
time To align bells, Eoosan pm plate cap screw align
puJIeva and secure with cap screw.
Augar/lmpeller Belt
For proper tension of auger/impellet bell, tip umt up on
auger.'i mpeller housing Chock tlial id lei pm is m position
with f!ot of pin toward
oenier of unit
Loosen lock nut far enough so that compression spnnq
and washer are tree lo rotate Then tighter^ nut until
spnng no longer lurns freoly From this position, tighten
lock nut exactly sight turns to provide
proper lension
on augen'impeller belt.
A WARNINtà; With improper use Injury may
result if clutch hall Is released and brake
DOES NOT STOP auger/lnipetler within 5
sebond^.
.^3
t. Connpreesbn Spnng
2. Look N lj I
3 Idler Pin
1 Cable End
Rgure7: Engine Balt Adjuatirent
Figure S: Augar/lmpeller Belt Adjustmant
11