Important safety instructions, Read ail instructions before using, Save these instructions – SINGER W213 User Manual
Page 3: Danger, Warning, This sewing machine)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

IMPORTANT SAFETY INSTRUCTIONS
......Whsn using an electrical aopiiance. basic safety precautions shouW always be
followed, including the following.
Read ail instructions before using
(this sewing machine)
DANGER
To reduce the risk of electric shock:
An appliance should never be left unatterfoed when plugged in. Always unplug this
appliance from the electric outlet immediately after using and before cleaning.
Always unplug before relartrping. Replace bulb with same type rated ”5 watts,
WARNING
To Induce the risk of burns, fire,
electric shock, or injury to persons:
1. Do not allow to be used as a toy. Close attention is necessary when this appliance
is used by or near children.
2. Use this appliance only for its intended use as described in this manual. Use only
attachments recommended by the manufacturer as contained In this manual.
3. Never operate this appliance if it has a damaged cord or plug, if it is not wrking
properly, If it has been dropped or damaged, or dropped into water. Return fie
appliance to the nearest authorized dealer or service center for examinatio.n, repair,
eleclfical or mechanical adjustment.
4. Never operate the appliance with any air openings blocked. Keep ventilation open
ings of the sewing machine and foot controller free from the accumulation of Hm,
dust, and loose cloth.
5. Never drop or insert any object into any opening.
6. Do not use outdoors.
7. Do not operate where aerosol (spray) products are being used or where oxygen is
being administered.
8. To disconnect, tun all controls to the off ("0”) position, then remove plug from
outlet.
9. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
10
. t^p fingers away from all moving parts. Special care is required around the sewing
machine needle.
11
. Always use the proper needle plate. The wrong plate can cause the needle to break.
13. Do not use bent needles.
13. Do not pull or push fabric while stitching, it may deflect the needle causing it to
break
14. Unplug the sewing machine when making any adjustments in the needle area,
such as threading needle, changing needle, threading bobbin, or changing
presser foot, etc.
15
. Always unplug sewing machine from the electrical outlet when removing covers,
lubricating, or when making any other user servicing adjustments mentioned in the
instruction manual.
SAVE THESE INSTRUCTIONS