SINGER P-1250 Professional User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
T O R E P L A C E T H E B O B B I N
Be sure to follow these steps carefully. If bobbin is incorrectly
placed, machine will not stitch properly.
1. With slotted end (A) to the right, PLACE filled bobbin into
case (8).
• LEAVE 3" (7.5cm) of thread outside case.
2. HOLD finger over case opening to keep bobbin m place, and
PULL thread completely into slot (C).
• SNAP thread back between the two metal guides (D).
• PULL 3" (7.5cm) of thread from case.
3. MOVE slide cover to the left.
• TURN hand wheel clockwise, moving carrier to the far left.
• With metal guides facing up, RETURN case to carrier (E).
• CLOSE cover, leaving about 3" (7.5cm) of thread on
outside.
-4-