To remove the dispenser for cleaning, To replace the dispenser – Maytag MAV-5 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
■' - i «' .fiJiT-
J
l
"
i
'•■
To Remove the Dispenser for
Cleaning
1) Support the bottom of the dispenser with
one hand. Use a quarter and turn four slot
ted screws counter clockwise 1/4 turn (fig
ure 1).
2) Pull the dispenser out from the bottom of
the lid.
3) Remove fill cap.
4) Fill with water about half way. Move the
dispenser from side to side to wash out
detergent.
5) With the dispenser over a large sink or bath
tub, turn it upside down to empty the
water/detergent out of the dispenser fill
area.
To Replace the Dispenser
1) Place the top of the dispenser in the top lip of the lid.
2) Push the bottom of the dispenser into the bottom of
the lid.
3) While supporting the bottom, use a quarter and turn
each of the four screws 1/4 turn clockwise to lock the
dispenser into place.
4) Close the washer lid.
5) Open the washer lid.
6) Press the “PUSH” button to release any remaining
water/detergent. Repeat steps 4-6 until no more
water can be drained from the dispenser. It is normal
for a small amount of water to remain in the dis
penser after cleaning.
7) Refill the dispenser with your favorite detergent (see
page 8).