SINGER 112W138 - Manual (Page 3)

INSTRUCTIONS FOR ORDERING
In ordering Trom this list, use ONLY the PART number In
the FIRST column.
The number stamped on a Sewing Machine Pari Is the num­
ber of the Single Part only, except when the part Includes
Set Screws, Clamping Screws, Studs and Rollers Spun on.
Small Wires riveted, or Parts soldered together, etc.,which
It Is necessary to furnish In combination.
Every combination of parts sent out has Its specific
number which, although not stamped on Parts (except In
above case), must be used when ordering the combination.
Each number always Indicates the SAME PART In whatever
list It appears, or for whatever Machine.
The letters after some of the numbers Indicate the
style of finish only, as follows:
A. Hardened, Polished, Nickel Plated and Buffed.
B. Polished, Nickel Plated and Buffed.
C. Hardened only.
D. Polished only.
E. .Soft, not polished.
F. Hardened and Polished.
H. Blued.
J. Nickel Plated only.
R. Merllzed.
X. Black Oxide.
XC. Hardened and Black Oxide.
Y. Blade Nickel only.
These letters MUST BE USED when they appear In the list
and AFTER the number, as In the list.
In this series:
200001 to 201500 and 350001 to 351500 are Screw Numbers.
201501 to 201800 and 351501 to 351800 are Nut Numbers.
201801 to 202000 and 351801 to 352000 are Roller Numbers.
202001 to 350000 are Numbers of Machine Parts.
The figures In the second column refer only to the
plate In which the Illustration of the part Is shown and
are NOT TO BE USED In ordering.
Two or more numbers over a cut Indicate that the dif­
ference between such parts Is not visible In an Illustra­
tion.
Parts marked with an asterisk (•) are furnished when
repairs are made at the factory.
LIST OF PARTS COMPLETE
FOR
MACHINE No. Il2wl38
HIGH SPEED. DROP FEED.
VERTICAL TRIMMER. BINDER.
HOOK AT LEFT OF THE NEEDLE.
MADE IN >/g INCH GAUGE THE TRIMMING MARGIN IS
CONTROLLED BY THE WIDTH OF THE BINDING,
No.
«248176
Píate Na.me
Arm with 202135 and 2011C01:
2,24002, 16270 M Cap
20017011 1G270 II " Screw
20224B 16270 II " " Washer
2042.35 16260 II Position Pin (2)
200004E 16260 If Screw (3)
202005 16260 It Washer (3)
22,4137 162,70 II Shaft with 200357F, and 224392
240602, 162,70 II
Bushing (back) with 202244
2022,44 16270 II " " " Oil Packing
2003.38C 16270 II " Set Screw
207080 16270 " " (front) with 202244
202244 16270 If " " " on Packing