SINGER 6211 - Manual (Page 13)

INSERTING A BOBBIN
To insert a bobbin, follow the instructions below:
Raise presser foot.
Turn hand wheel toward you until
needle is in its highest position.
Open slide plate and remove empty
bobbin.
. Pull 4" (10cm) of thread from
replacement bobbin and insert bob­
bin into case, as shown.
2. Holding bobbin in place, guide
thread into notch (1) and then down
the slot to the left and guide around
into notch (2).
3. Draw several inches of thread diago­
nally across the bobbin toward the
back of the machine.
4. While holding thread on outside,
close the slide plate, allowing thread
to extend through the slot between
the slide plate and needle plate.
• Follow directions for “Raising Bob -
bin Thread” on page 13.
11