SINGER W1630 - Manual (Page 33)

J
...^^- I..............................i'
:='-'■« »«W'W .i‘
CHECKING PERFORMANCE PROBLEMS WHAT TO DO
to
O
PROBLEM
PROBABLE CAUSE
CORRECTION
Fabric not
moving
-- Feed dog down.
- Machine not moving.
- Stitch length dial in 0 position.
- 1 ight pressure on presser foot.
- Raise feed dog.
- Moving stop motion.
- Moving dial to 1-4.
- Increase pressure on presser foot.
Breaking Needle
— Incorrect setting of needle.
Needle bent.
— Pulling fabric.
— Incorrect using needle, thread and fabric.
— Reset needle,
— Replace new needle.
— Do not pull fabric.,
— Correct using needle, thread, and fabric.
Breaking Upper
Thread
- Incorrect position of zigzag width dial.
- Improper threading.
- Tight upper thread tension.
- Needle bent.
- Nicks or burrs on shuttle.
- Moving to correct position.
- Rethread machine.
- Loosen upper thread tension.
- Replace new needle.
- Replace shuttle, or polish off burrs
completely.
Breadkin Bobbin
Thread
- Tight bobbin thread tension.
Incorrect setting of needle.
- Improper threading.
- Dust and thread in shuttle.
— Loosen bobbin thread tension.
— Reset needle.
- Rethread machine.
- Clean shuttle.
Machine Jamming
Knocking Noise
- No oil.
- Dust and thread in shuttle.
- Need oil.
- Clean shuttle.
Puckering
- Tension too tight.
- Sewing foot pressure too strong.
- Incorrect using fabric, needle, and thread.
- Reset.
- Regulating sewing foot pressure.
- Correct using fabric, needle and thread.