Maytag T1 - Manual (Page 9)

IM.
i Surface Cooking
Surface Cooking CAUTIONS:
Before Cooking
• Always place a pan on the surface unit before you turn
it on. To prevent damage to range, never operate
surface unit without a pan in place.
• Do not use the cooktop as a storage area for food or
cookware.
During Cooking
• Be sure you know which knob controls which surface
unit. Make sure you turned on the correct surface unit.
• Begin cooking on a higher heat setting then reduce to a
lower setting to complete the operation. Never use a
high heat setting for extended cooking.
• Never allow a pan to boil dry. This could damage the
pan and the appliance.
• Never touch cooktop until it has cooled. Expect some
parts of the cooktop, especially around the surface
units, to become warm or hot during cooking. Use
potholders to protect hands.
After Cooking
• Be sure surface element and surface indicator light are
off after cooking.
• Clean up messy spills as soon as possible.
Other Tips
• To eliminate the hazard of reaching over hot surface
elements do not install cabinet storage directly above a
unit.
If storage is provided, limit it to items that are infre­
quently used and can be safely stored in an area sub­
jected to heat.
Temperatures may be unsafe for items such as volatile
liquids, cleaners or aerosol sprays.
• Aerosol-type spray cans are EXPLOSIVE or highly
flammable when exposed to heat. Avoid their use or
storage near an appliance.
• Do not leave any items, especially plastic items, on the
cooktop. The hot air from the vent may ignite flam­
mable items, melt or soften plastics, or increase pres­
sure in closed containers causing them to burst.
• Do not allow aluminum foil, meat probes or any other
metal object, other than a pan on a surface element, to
contact heating elements.
Surface Controls
Use to turn on the surface elements. An infinite choice of
heat settings is available from LOW to HIGH. The knobs
can be set on or between any of the numbered settings.
Setting the Controls
1. Place pan on surface element.
2. Push in and turn the knob in either direction to the
desired heat setting.
• The backguard is marked to identify which element
the knob controls. For example, 'i' 'IIH‘ indicates right
front element.
'®'' ®
Dual Element - Select glass-ceramic cooking surfaces
are equipped with a dual element located in the right front
position. To operate, push in on '
the control knob and turn to
the left to control the large ^ ®
element or push in and
turn to the right to con-^
trol the small element.
Suggested Heat Settings
The size and type of cookware will affect the heat setting.
For information on cookware and other factors affecting
heat settings, refer to “Cooking Made Simple” booklet.
Setting Uses__________ ________________
Use to bring liquid to a boil, blanch, or reach
HIGH pressure in a pressure cooker. Always reduce
setting to a lower heat when liquids begin to
boil or foods begin to cook.
7-8 Use to brown meat, heat oil for deep fat
Med. Hi
frying, saute or fry. Maintain fast boil for
large amounts of liquids.
4-6 Use to maintain moderate to slow boil for
Med. large amounts of liquids and for most frying
operations.
2-3 Use to continue cooking covered foods and to
Med. Lo maintain pressure in most pressure cookers
and stew or steam operations.
Use to keep foods warm and melt chocolate
LOW and butter.
8