SINGER 122W - Manual (Page 3)

Instructions for Ordering
In ordering from this list, use ONLY the PART number In
the FIRST column.
The number stamped on a Sewing Machine Part is the
number of the Single Part only, exce])t wlien tlie jiart inchuies Set
Screws, Clamping Scia'ws, St\ula and Itoliers S]iun on, Small
Wires riveted, or Parts soldeied tngetlier, ('Ic., which It Is
necessary to furnish in combination.
Every combination of parts sent out has its specific number
which, although not stamped on Parts (exce))t in above cases)
must be used when ordering the comldnation.
Each number always indicates the SAME PART in whatever
list it appears, or for wliatever Machine.
The letters after some of the numliers indicate the style of
finish only, as follows:
A. Hardened, Polished and Plated.
! B. Polished and Plated.
C. Hardened only.
D. Polished only.
E. Soft, not polished.
F. Hardened and Polished.
H. Blued.
These letters MUST BE USED wlien they appear in the list
and AFTER the number, as in the list.
In this series
200001 to 201500 are Screw Numbers.
201501 to 201800 are Nut Numbers.
201801 to 202000 are Roller Numbers.
202001 and upward are numbers of Machine Parts.
The figures in the second column refer only to the plate
in which the illustration of the part is shown and are NOT TO
BE USED in ordering.
Two or more numbers over a cut indicate that the difference
between such parts is not visible in an illustration.
Parts marked with an asterisk (♦) are furnished only when
repairs are made at the factory.
L I S T O F P A R T S C O M P L E T E
FOR
MACHINE No. 121wl
NEEDLE FEED. ALTERNATING PRESSERS.
For Sewing Rough, Uneven or Sticky Goods.
No. Plate Name Each
*213451 ------ Arm..................................................................... ? —
202247 11055 “ Cap ............................................ 25
20027SII 12.111 “ “ Screw ........................................ 0.5
202248 11701 ...................... Washer .............................. 05
204215 11701 “ Position Pin (2) ................................... 02
200004r: 110(11 “ Screw (1) ........................................ 08
202005 11701 “ “ Washer (1) ...................................... 01
21.3401 11183 “ Shaft ...................................................... 1 75
20224.3 11055 “ “ Bushing (back) wltli
202244 ........................................................... 75
202244 ----- Arm Sliaft Bnsliing (back) Oil
Packing (wick) ............................................... 02
200338c 11701 Arm Sliaft Bushing (back) Set
Screw ............................................................. 04
213452 11055 Arm Shaft Bushing (front) with
202260 ........................................................ .15