Placing bobbin case in shuttle, Upper threading (fig. 10) – SINGER W1066 (older model) User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
10
PLACING BOBBIN
CASE IN SHUTTLE
Raise needle bar to high
est position, and lift hinged
cover plate. (See 10, Fig
1.) Hold the bobbin case
latch, ( D), Fig. 9, between
the
thumb
and
forefinger
of the left hand, with at
least three inches of thread
running from the top of the bobbin case to the right.
Insert and center the bobbin case on the stud of the
shuttle body,
(C).
Be sure the
bobbin case finger,
(E), is opposite the shuttle race notch, CA).
the bobbin case (B) into the shuttle as far as possible
until latch catches on the center post of the shuttle.
THEN
release
the
bobbin
case
latch,
(D).
Press
bobbin
case again after latch has been released to
make sure the bobbin case is locked securely in place.
Close the cover plate.
UPPER THREADING
(Fig. 10)
1. Turn the balance wheel toward you to raise
the take-up lever to its highest position.
2. Place a spool of thread on the spool pin.
3. Lead the thread through the upper arm thread
guides.
THRE
QUID