Checking performance problems what to do – SINGER W1744 User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

CHECKING PERFORMANCE PROBLEMS WHAT TO DO
w
o
PROBLEM
Fabric not
moving
Breaking Needle
Breaking Upper
Thread
Breadkm Bobbin
Th ead
Puckering
PROBABLE CAUSE
Machine Jamming
Knocking Noise
Feed dog down.
Machine not moving.
Stitch length dial in 0 position
Light pressure on presser foot.
Incorrect setting of needle.
Needle bent
Pulliny fabric
,
Incorrect using needle, thread and abric......
Incorrect position of zigzag width dial.
Improper
threading
Tight
upper
thread tension
Needle bent,
Nicks
or
burrs
on
shuttle
Tight
bobbin
thread
ten on
Incorrect
setting
of need
e.
Improper threading.
Dust and thread n shuttle
No oil
Dust and thread in shuttle
CORRECTION
Raise feed dog.
Moving stop motion.
Mov ng dial to 1-4.
Increase piessure on pi
Reset needle.
Replace new needle.
Do not pull fab ic.
sser foot.
Correct using needle, thread, and fabr c.
Tension too tight.
Sewing foot pressure too strong.
Incorrec us'ng fab ic needle, and thread
Moving to correct position.
Rethreai-i machine.
Loosen upper thread tension.
Replace new eedle.
Replace shuttle
o i
pol sh off burrs
comp etely
Loosen bobbm thread tension
Reset needle.
Rethread mach ne.
Need o I
Clean shuttle
Reset.
Regulatin sewing foot pressure.
Correct using fabric, needle and thread.