Maytag MD6200 - Manual (Page 6)

CONTROLS AT A GLANCT
AUTODRY WRINKLE FREE FABRICS with
PRESS CARE is designed for permanent press or man­
made fabrics such as acrylic, nylon, polyester or blends. It min­
imizes wrinkling by providing an unheated cool down period at
the end of the cycle. Simply set the control to the desired dry­
ness level (more dry - less dry). The line between MORE or
LESS DRY is the initial preferred setting for the majority of
loads.
AUTODRY REGULAR is designed for loads such as
towels, underwear, t-shirts, jeans, etc. Set the control to the
desired dryness level (more dry - less dry). The line between
MORE or LESS DRY is the initial preferred setting for the
majority of loads.
COOL DOWN
LESS DRY
A U T O D R Y
WRINKLE FREE
FABRICS
W I T H P R E S S C A R E
MORE DRY
OFF MORE DRY
LESS DRY
OFF
A U T O D R Y
REGULAR
WRINKLE RELEASE DAMP DRY
TIME DRY/
AIR FLUFF
WRINKLE RELEASE will release
wrinkles from items that are clean and dry
but slightly wrinkled, such as from a crowded
closet, packed suitcase or from sitting in the
dryer too long after the end of the cycle. It
provides 10 minutes of heated tumbling and
5 minutes of cool down tumbling without
heat.
DAMP DRY is designed to “partially”
dry items. It provides approximately 20
minutes of heated fumbling and 5 min­
utes of cool down tumbling without heat.
TIME DRY/AIR FLUFF may be
selected for any load if the AufoDry
sensor system is not used. Set the
control to the desired number of
minutes.
NOTE: The dial can be turned in either direction to select a cycle. Once started, the dfat vii'ifislsdyant® at a spe­
cific rate during the AutoDry cycles. At fbet the dial may not advance at all. Toward ^he end'd (when the
load begins to dry) the dial will advance at a more regular rate and much more quiddy: This is normal operation.
5