SINGER W612 - Manual (Page 48)

48
for portable installation
Please read these .mportant .nstruct.ons which
^ere written to aid you m placing your new
sewing machine on its portable base.
F,st. remove the nail which holds the foot
cantrol inside the base to avoid damage in ship-
If a small plastic clamp is fastened
"o ?he back and not to the top of the partition
at one end of the base, remove it. too.
After unpacking the sewing machine unit,
being certain to take out the instruction book,
guarantee and accessory box, lay the unit face
down on a table. You will see two clamping
.crews A entering head hinge holes B on the
underside of the back.
On the base you will find two head hinges
C which will fit into holes B. Lower the base
onto the sewing machine fitting hinges C mto
holes B. Tighten screws A securely with a
screw driver.
With machine in sewing position attach pi
tic clamp D to top of partition with screw (
ovided so that it may be turned across the
of the machine, to hoU it down. (On son
bases the clamp may be positioned in the p
per spot).
To make the electrical connection draw t
two wires through the slot in the partition c
the base. Plug the cord labeled Motor :
the receptacle marked “Motor” on the bloc
attached to the outer section of the base. 1
insert the other cord into the Light recep
Place the foot control on the floor, inser
plug into a wall outlet (110-115 volts) and
are ready to sew. But first read the instru
book to become familiar with the threading
the machine, tension adjustments and all th.
other features designed to make sewing a s
a sure.